Spike Camp

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Rayford

Pages: [1]
1
Rifles / Re: Accumark Lapua Jitters
« on: June 09, 2014, 11:27:58 PM »
I use Hoppes Benchrest copper remover for cleaning.  Drag a clean patch through and then run a patch soaked with Hoppes  through and let it sit over night and next morning run a brush through and clean patch.  My barrel fouled bad and was hard to get clean until I got about 100 rounds through it and smoothed out the lands.  It cleans a lot easier now and doesn't foul nearly as bad!

2
Rifles / Re: Accumark Lapua Jitters
« on: June 09, 2014, 11:14:03 PM »
Mine likes the 300 grain Lapua Scenars, but I handload them.  On break in I handloaded some 300 gr Berger OTM Hybrids and fired and cleaned every shot for the first ten and then shot 10 three shot groups cleaning between groups.  I removed as much copper between groups as possible.  Mine shoots sub MOA groups now and usually 1/4 to 1/2 MOA after I put 1 fouling round through it.  It always throws the clean barrel round a little wildly.  I have about three hundred rounds through it now, and on a good day when I do my part I get sub MOA groups at half a mile. 

3
Equipment / My Accumark 338 Lapua Mag has broken extractor
« on: June 09, 2014, 10:36:06 PM »
Can anyone out there tell me where I can order a new extractor for my Accumark 338 Lapua mag? 

Pages: [1]